







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Oakley, CA: What It Costs and How Long It Takes
A chain link fence in Oakley, CA typically runs $3,500 to $9,000 for a standard residential lot, with most single-family properties landing between $4,200 and $6,800. A typical 150- to 200-foot perimeter is a two- to three-day job once permits clear, and you can usually be walking the finished line within a week of the first call. For an exact number on your property, call (888) 276-8078 and we’ll set up a free on-site estimate.
How We Build a Chain Link Fence in Oakley, Start to Finish

Every chain link job follows the same sequence. Here’s what actually happens, day by day, and where you make decisions.
Stage 1: Site walk and layout (Day 1, about an hour). We walk the property line with you, confirm corners and gate locations, and check for the things that trip up fences on former farmland: old irrigation lines, buried sprinkler valve boxes, and shallow drainage tile left over from the orchard era. You decide the fence height, gate swing direction, and whether the fabric faces in or out. That last one matters more than people expect on a shared property line.
Stage 2: Utility locate and permit (Days 1 – 2, waiting on the call-back). We call in the 811 locate before anything gets dug. On infill lots around Oakley, this is where we occasionally find a lateral the previous owner never documented. We pull the fence permit if your lot needs one (more on that below) and confirm any HOA submittal requirements. You sign off on the layout before we dig. Nothing moves forward without that.
Stage 3: Demolition and post setting (Day 2). If there’s an old fence, we tear it out and haul it off the same day. Post holes get dug to depth, set in concrete, and left to cure. On Delta-edge soil we dig a little deeper and set a wider concrete collar, because variable fill on former ag parcels doesn’t hold a post the way undisturbed ground does. This is a half-day to full-day stage depending on footage.
Stage 4: Framing and fabric (Day 3). Top rail, tension wire or bottom rail, and the chain link fabric go up. Gates get hung and adjusted for swing. We tension the fabric by hand and check every line for sag before we call it done. A 150-foot run is a comfortable day; 300 feet pushes into a fourth day.
Stage 5: Walkthrough and cleanup (end of Day 3). You walk the fence with us, we tighten anything that needs it on the spot, and we haul away every scrap of old material and concrete. Final sign-off happens with you standing at the gate, not over the phone.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Chain Link Options You’ll Choose Between
Chain link looks simple from the street. Up close, there are half a dozen decisions that change both the price and how the fence ages in Oakley’s sun.
- Galvanized vs. vinyl-coated fabric. Plain galvanized is the budget choice and holds up fine, but it dulls to a gray patina within a few seasons. Vinyl-coated (usually in black or green) adds roughly 15 – 25% to material cost and keeps its color through the Delta heat, which matters when your fence faces west and takes full afternoon sun.
- Gauge and mesh size. Standard residential is 11.5-gauge in a 2-inch mesh. Going to 9-gauge gives you a visibly heavier fence that resists dogs and kids leaning on it, at a modest upcharge. For a property line that borders open space or a drainage channel, thicker is worth it.
- Height. Four feet is the code-friendly default for most residential lots. Five and six feet are common for privacy and pet containment but often trigger HOA review and, on some parcels, a height restriction in the front yard. We check before we order.
- Posts and top rail. Line posts at 2⅜-inch, terminal posts at 2⅞-inch, with a top rail in the same gauge as the fabric. Terminal posts at corners and gates are what keep the fence from leaning after a few winters, so we never cheap out on those.
- Gates. Walk gates in steel frame with self-closing hinges and a latch that actually lines up. Drive gates come in single-swing or double-swing, and if you’re parking a trailer or boat behind the fence, a wider double gate is worth the step up.
- Tension wire vs. bottom rail. Tension wire is cheaper and keeps a tighter bottom edge on uneven ground. Bottom rail looks cleaner and holds up better if you’ve got a dog that likes to dig.
What Chain Link Fence Costs in Oakley, CA

Plan on $3,500 to $9,000 for a residential chain link fence in Oakley. Here’s how the line items break down so you can see where your number comes from.
| Line item | Typical range |
|---|---|
| Fence removal and haul-away | $300 – $900 |
| Posts, concrete, and setting | $1,200 – $3,000 |
| Fabric, top rail, and tension wire | $1,000 – $2,800 |
| Walk gate (installed) | $350 – $700 |
| Drive gate (installed) | $700 – $1,800 |
| Permit and inspection fees | $150 – $500 |
Five things push a job toward the high end: total linear footage (a 100-foot corner lot and a 300-foot perimeter are different projects), whether the ground is level or needs grading, an old fence or buried concrete to remove, the upgrade from galvanized to vinyl-coated in a heavier gauge, and whether the permit scope requires a survey to establish the property line. A written estimate from us is line-item and no-hassle upfront pricing: the number you see is the number you pay, with no change orders unless you add work. What’s typically not included is a property-line survey if there’s any question of encroachment, and any site prep needed to deal with old orchard infrastructure. We’ll flag both before you sign anything.
See the difference
Before
After
Before
After
Before
AfterWhat Oakley Homes Specifically Do to This Chain Link Fence Job
Oakley is a former agricultural Delta town, ZIP 94561, that’s turned orchards and farmland into one of East Contra Costa County’s fastest-growing bedroom communities. That history shows up in the ground. When we set posts on a lot that used to be an orchard, we regularly hit old irrigation lines, variable fill, and drainage tile that’s decades past its service life. On the newer planned-community side, houses built in the 1980s through the 2010s sit on compacted tract soil with a fairly consistent grade, which makes fence work faster and more predictable. Either way, we do a locate and a soil check before the first post hole gets dug.
The other Oakley-specific factor is drainage. Flat former farmland near the Delta edge doesn’t shed winter rain the way sloped in-town lots do, so a fence line that sits in a low spot needs posts set deeper and fabric tensioned a little tighter to resist heaving and settling. And when a homeowner’s putting up a chain link fence on a shared property line in the newer subdivisions off Laurel Road or the older pockets near Main Street, we always confirm the actual line before we build. Encroachment disputes are cheaper to prevent than to unwind. This work often runs alongside a full Fence Installation in Oakley when a homeowner is fencing the whole property line or adding a separate privacy section.
Serving Oakley, CA – Our Local Coverage Area
We serve Oakley and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Oakley

Two to three days for a standard 150- to 200-foot residential perimeter, from dig to walkthrough. Larger lots and jobs that need demolition of an old fence can stretch to four days. You’ll know the schedule before we start, and the 730-Day Done Right Promise covers the workmanship on every panel and gate.
It depends on height and location. Most residential fences at four feet on an interior property line don’t require a permit, but anything taller, or a front-yard fence, usually does, and some HOA subdivisions require an architectural submittal regardless. We confirm the requirement for your specific lot during the estimate, pull the permit if it’s needed, and schedule the inspection. Call (888) 276-8078 for a clear answer on your property.
No. Our estimates are line-item and fixed. The only time the number moves is if you add scope (an extra gate, a longer run) or if we hit something buried that couldn’t have been found on the locate, which we’ll stop and walk you through before doing anything. No-hassle upfront pricing means no surprise invoices.
Most residential jobs land between $3,500 and $9,000, with the average around $4,200 to $6,800 depending on footage, height, and whether you’re upgrading to vinyl-coated in a heavier gauge. Call (888) 276-8078 for an exact quote – estimates are free and on-site.
Every fence we build is backed by our 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If a post settles, a gate stops latching, or fabric sags, we come back and make it right. That’s the whole point of the guarantee, and it’s in writing. Our technicians have up to 12 years of experience building and repairing fences throughout the region.
Get a Free Chain Link Fence Estimate in Oakley
Call (888) 276-8078 to schedule your free on-site estimate for a chain link fence in Oakley. We’ll walk the property line, check for buried irrigation and utility conflicts, and hand you a line-item written estimate the same visit. From a back-lot pet containment run to a full perimeter in a new subdivision, this is straightforward work and we price it that way. For the wider whole-property scope, see our Fence Installation service, or check Oakley for the neighborhoods we cover. Homeowners often pair this with ADU Site Prep & Utilities in Oakley when clearing a site, or with Door Installation in Oakley when gates and exterior doors get upgraded together. Calls are answered by a live person 24/7, and every technician arrives background-checked and in uniform.
Written by the team at Groundwork Construction Co.












