







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Bay Point, CA: What It Takes
An asphalt driveway in Bay Point usually runs $3,500 – $9,000 for new paving and $250 – $700 for a reseal, with most driveways finished in one to three days depending on size and how much base work the Delta soils demand. A full tear-out and replacement lands in the $5,000 – $14,000 range. Call (888) 276-8078 and we’ll walk your driveway, check the base, and hand you a written line-item number before anything gets scheduled.
How we actually build an asphalt driveway here, stage by stage
Asphalt is unforgiving about what’s underneath it. In Bay Point, where flatland lots near the shoreline often sit on fill, the base prep is usually the difference between a driveway that lasts twenty years and one that cracks apart in three. Here’s the sequence we follow.
- Site visit and measurements (day 1, about an hour). We measure the run, check slope and drainage away from the garage, and probe the existing base. On older flatland properties off the shoreline streets, that probe tells us fast whether we’re paving over stable fill or digging out soft spots. You decide the footprint and whether drainage needs to change.
- Demo and haul-off (day 1, half to a full day). Old asphalt, broken concrete, or gravel comes out and goes to the yard. On a 400-square-foot driveway this is a morning. On a long double-wide run it’s most of a day, plus dump fees. You sign off on the final grade and edges before we move on.
- Base prep and compaction (day 1 into day 2, the stage that matters most). We grade the subgrade, bring in class 2 base rock, and compact it in lifts of 2 to 4 inches. On Delta-adjacent fill soils we may over-excavate and re-compact 6 to 8 inches deep. This is where you decide base thickness – 4 inches for a car-only driveway, 6 inches where an RV or heavy truck parks.
- Asphalt laydown (day 2, one to two hours of actual paving). Hot-mix asphalt goes down at 2 to 3 inches compacted for residential use. We roll it while it’s hot, shape the edges, and set the transition at the garage apron and street apron so water runs off instead of pooling.
- Cure and seal timing (day 2 cure, seal at 6 – 12 months). The surface cures over a few days – keep heavy vehicles off it for 48 to 72 hours. Sealing happens after the first full season, once the asphalt oils have oxidized. You decide then whether to reseal every two to three years, which is what keeps a Bay Point driveway from drying out under the sun and wind.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The real choices you’ll make on an asphalt driveway
Most of the decision-making happens before the first shovel hits the ground. Here’s what actually changes the job:
- New asphalt versus overlay (resurfacing). Resurfacing an existing sound driveway costs roughly $2,500 – $6,000 and buys you 8 to 12 years. New construction is the $3,500 – $9,000 range and lasts far longer. The honest trade-off: resurfacing is cheaper and faster, but it inherits every flaw in the base underneath. If the existing driveway is heaving or alligatored, overlay just buries the problem.
- Base thickness. Four inches handles a sedan. Six inches is the right call if you park a boat, trailer, or work truck, and it’s a real cost adder on material and haul-off.
- Hot-mix versus cold-patch repairs. For small cracked sections, cold patch is a $50 – $150 stopgap. It’s not a fix, and in a Bay Point summer it can soften and rut. Hot-mix repairs from a batch plant hold up far better if the repair area is big enough to justify the trip.
- Sealer type. Asphalt emulsion sealer is the standard and sits in the $250 – $700 reseal range. Coal tar sealers are still sold in some markets but we steer clear of them – the runoff concerns near the Delta watershed aren’t worth the marginal durability gain.
- Edge treatment. A compacted rock shoulder is cheap. A poured concrete curb or a border of brick pavers holds the edge better and dramatically improves the look – that’s where a lot of homeowners pair the asphalt with our Driveway & Pavers work for the border detail.
What asphalt driveways & resurfacing cost in Bay Point, CA

Here’s the range we actually quote in this ZIP, with the variables that push a job from one end to the other.
| Scope | Typical Bay Point range |
|---|---|
| Reseal / seal coat | $250 – $700 |
| Asphalt paving (new driveway) | $3,500 – $9,000 |
| Full replacement (demo + new asphalt) | $5,000 – $14,000 |
What moves you toward the top of those numbers:
- Square footage. A single-car pad is at the bottom. A long double-wide run or an RV pad is at the top.
- Base condition. Soft fill or failing subgrade means over-excavation and imported rock, which adds $1,500 – $3,500 depending on how deep it goes.
- Drainage and grading. If water currently runs toward the house or garage, adding a swale, trench drain, or re-grading is a real scope item, not a nice-to-have.
- Access and haul distance. Tight side yards slow down demo and paving.
- Permitting. Driveways that touch the county right-of-way or cross a curb line need a permit and inspection – we pull those and pass them, and we build that cost into your written number so there’s no surprise after the fact.
Every estimate is line-itemed: demo, haul-off, base rock, compaction, asphalt tonnage, and seal schedule. That’s how we keep upfront pricing honest.
See the difference
Before
After
Before
After
Before
AfterWhat Bay Point homes specifically do to this job
The physical reality of Bay Point changes an asphalt driveway more than it does most exterior work. The Delta wind and marine layer off Suisun Bay keep the air cool and damp, but that same constant airborne moisture and salt-laden air accelerates oxidation on asphalt – a driveway here weathers faster than one fifteen miles inland in Concord. The unincorporated county jurisdiction is the other big factor: permits and inspections run through Contra Costa County, not a city building department, so anything that touches the public right-of-way moves on the county’s schedule, not ours. On the flatland lots near the shoreline, we regularly see soft spots where the fill has settled and drained poorly for years – that’s why we probe before we quote. The mid-century ranch homes in the flatlands often have short, narrow driveways that got paved decades ago and are now alligatored and heaving; the newer stucco-and-tile hillside homes toward the Concord border usually just need a reseal. Same town, same ZIP (94565), two very different jobs.
We cover the full spread of Bay Point – shoreline flatlands, the hillside tracts, and everything between. If your scope grows into a broader site project, that’s covered on our Driveway & Pavers in Bay Point page, and neighbors building backyard structures often pair the driveway work with an Chain Link Fence in Bay Point or ADU Site Prep & Utilities in Bay Point scope while the equipment’s already out.
Serving Bay Point, CA – Our Local Coverage Area
We serve Bay Point and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQ: Asphalt Driveways & Resurfacing in Bay Point

Most asphalt driveways are paved in two working days – one day of demo and base prep, one day of laydown – then cured for 48 to 72 hours before you drive on it. Larger jobs with deep base excavation can stretch to three to four days. Call (888) 276-8078 and we’ll give you a firm timeline based on your actual site.
You need a permit when the work touches the county right-of-way, the street apron, or a curb line – and that includes some common replacements on flatland lots near the shoreline. Driveways entirely inside your property line usually don’t require one. Contra Costa County handles both scenarios for unincorporated Bay Point, and we pull the permit and pass the inspection as part of the job.
Yes – if the existing base is sound and the cracking is surface-level. Resurfacing runs roughly $2,500 – $6,000 and adds 8 to 12 years. If the driveway is heaving, alligatored, or sitting on settled fill, an overlay just hides a base problem and fails within a couple of seasons. We probe before we quote so you know which scenario you’re in.
New asphalt paving runs $3,500 – $9,000, a full tear-out and replacement lands in the $5,000 – $14,000 range, and resealing is $250 – $700. Base condition and drainage are the biggest variables in this ZIP. Call (888) 276-8078 for a written line-item estimate – the on-site visit is free.
Every asphalt driveway we install is backed by our 730-Day Done Right Promise – if something isn’t right, we fix it. That covers our workmanship, the base prep, and the laydown. We also pull permits and pass inspections, so the county sign-off is part of the record. Call (888) 276-8078 with any warranty question and we’ll walk you through what’s covered in writing.
Get a free asphalt driveway estimate in Bay Point
We’ll come out, probe the base, talk through resurfacing versus new construction, and leave you with a written line-item number – no pressure, no vague “ballpark” verbal quotes. Call (888) 276-8078 to schedule your free on-site estimate for asphalt driveways & resurfacing in Bay Point. A live person answers around the clock if you’d rather call in the evening. We cover the full Bay Point area, flatlands to hillside.
Written by the team at Groundwork Construction Co.












