







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Bay Point, CA: What the Job Actually Involves
A paver driveway in Bay Point runs $7,000 to $18,000, and most drives are finished in three to six working days once the base is prepped and inspected. The range covers demolition of the old surface, a compacted aggregate base, edge restraint, and the pavers themselves. Where it lands in that range comes down to square footage, whether the existing base is sound, and how much drainage work the lot needs. Call (888) 276-8078 and we’ll walk your drive and put a real number in writing.
The reason Bay Point drives need more upfront thinking than most: shoreline fill, the Delta breeze, and the county jurisdiction all change how a paver drive gets built here. That’s the ground we cover below.
How We Build a Paver Driveway, Stage by Stage

Every paver drive we install follows the same sequence. What changes is how much of it your lot needs.
Stage 1: Site walk and layout (day 1, half a day)
We mark the drive’s edges, check the existing slope for where water actually leaves the property, and confirm what’s underneath – old concrete, gravel, or bare fill. On the flatland lots near the shoreline, this is where we decide whether the base needs a fabric separator. You approve the layout before anything gets torn out.
Stage 2: Demolition and excavation (day 1 to 2)
Old concrete or asphalt comes out and gets hauled off. We excavate to a depth that gives us 6 to 10 inches of compacted aggregate base under the pavers, deeper where soils are soft. A drive that sat on fill may need excavation deeper than a hillside tract driveway would.
Stage 3: Base and compaction (day 2 to 3)
Crushed aggregate goes in lifts, each watered and compacted before the next. This is the stage most cheap paver jobs skip, and it’s the stage that decides whether your drive still looks flat in year five. If a permit is required, the county inspects here, before pavers cover it.
Stage 4: Edge restraint and sand-set installation (day 3 to 5)
Concrete or plastic edge restraint goes down on both sides, then the pavers get laid and cut at the corners and near the garage apron. Joint sand goes in last and gets vibrated into the gaps. You pick pattern and color before we order – that decision locks in week one, not day three.
Stage 5: Final clean and walkthrough (day 5 to 6)
We wash the drive, sweep the joints, and walk it with you. Any paver that rocks or sits proud gets pulled and reset. That walkthrough is attached to the 730-Day Done Right Promise. If something shifts or settles in the first two years, we come back and make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Most of your decisions happen before a single paver shows up. Here’s the honest trade-off on each.
- Interlocking concrete pavers (Belgard): the standard choice, $7,000 to $18,000 all-in for a typical drive. Wide color range, easy to pull and reset a section if you ever need to get at a utility line, and they hold color better than brick under marine air.
- Clay brick pavers: the oldest look, and the one that ages most gracefully. More expensive per square foot, and the mortar joints or sand joints need occasional refilling. Suits the older cottages and ranch homes in the flatlands.
- Concrete slab pavers (large-format): fewer joints, a modern look. Heavier, so the base work matters even more, and you can’t easily lift and reset one piece without a machine.
- Pattern: herringbone holds up best to tire wear and turning, running bond is faster and less expensive. On a long service drive you’ll see the herringbone pay off where wheels spin.
- Permeable joints: a sand joint with a polymeric product lets water drain rather than sheet off. Worth the small upcharge on any drive that pools, which is common on shoreline-adjacent lots.
What Paver Driveways Cost in Bay Point, CA

Paver driveway installation in Bay Point runs $7,000 to $18,000. That price covers demolition, haul-away, base prep, edge restraint, pavers, and sand. Here’s what pushes a job toward the low or high end:
- Square footage: the single largest driver. A short two-car drive sits near the low end; a long service drive to a detached shop sits at the top.
- Existing base condition: a sound gravel base saves excavation and hauling. Old concrete slab means breaking, loading, and dumping – a real cost line.
- Drainage and fill: shoreline-adjacent lots on fill sometimes need a fabric layer, a deeper base, or a small French drain to move water off the drive. That work pushes any job higher.
- Paver grade and pattern: premium clay brick and complex herringbone patterns cost more in material and labor than a running-bond concrete paver install.
- Permit scope: where a permit is required, the county approval and inspection adds a line item and a few days to the schedule.
A written estimate itemizes each of those, so you see the base square footage, base depth, paver type, and drainage scope before you commit. We don’t change the number once work starts. If we find something under the surface that nobody could have seen, it gets priced and you approve it before we touch it.
See the difference
Before
After
Before
After
Before
AfterWhat Bay Point Properties Specifically Do to This Job
Bay Point runs on a county jurisdiction, not a city building department. Permits and inspections go through Contra Costa County, and what triggers a permit on a driveway often comes down to the drainage and impervious-surface rules rather than the pavers themselves. On the flatland pockets near the shoreline, lots often sit on fill, and that changes how deep we go on the base and whether we add drainage. Those same lots are in the persistent Delta breeze, so joints need to be kept full and edge restraint has to hold against wind that works at the drive from the side.
The housing stock is a patchwork, and we work both ends of it in a single ZIP. Mid-century ranch homes and older cottages – the ones where a paver drive finally replaces a cracked slab – sit a few streets from newer hillside stucco-and-tile homes toward the Concord border, where the drive might need a retaining edge or grade correction instead of a fresh base. You’ll see us on a real mix of these.
When your paver drive gets bundled with a wider plan – replacing the old garage door on that detached shop, or a kitchen refresh once the drive is done – homeowners often pair this with Door Installation in Bay Point or Cabinets & Countertops in Bay Point, though those are separate jobs on their own schedule.
Serving Bay Point, CA – Our Local Coverage Area
We serve Bay Point and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Paver Driveways in Bay Point

Three to six working days for a typical drive, with the base and compaction stages taking the longest. Larger drives on acreage and jobs with drainage work run longer. Weather can add a day, so call (888) 276-8078 and we’ll scope the timeline to your property.
Often yes, because permits and inspections here run through Contra Costa County rather than a city office, and the trigger is usually tied to drainage or impervious surface. We confirm what applies to your specific lot before any work begins, and if a permit is needed, we pull it. Call (888) 276-8078 and we’ll walk through it.
No – the number we quote is what you pay. If we hit something unexpected under the surface, like buried debris or unsound fill, we stop, price it, and get your approval first. Call (888) 276-8078 for a written line-item estimate.
In most cases, yes. We protect the edges and keep excavation inside the drive footprint. If a retaining edge or drainage tie-in needs to push a little past it, that’s discussed before we start. Call (888) 276-8078 and we’ll scope it during the on-site estimate.
The 730-Day Done Right Promise covers workmanship – if a paver settles or the base shifts, we come back and fix it. That’s one of the longest workmanship guarantees in residential construction. Questions? Call (888) 276-8078.
Get a Free Paver Driveway Estimate in Bay Point
We’ll walk your drive, check the base and drainage, and hand you a written estimate with every line itemized. That’s for paver driveways in Bay Point, and it’s also part of a full Driveway & Pavers in Bay Point scope if you’re redoing the whole approach. If you’re still weighing materials, our Driveway & Pavers service page covers the options. We cover all of Bay Point, including the flatland pockets and the hillside stretches toward the Concord border. See our full Bay Point service area. Calls are answered by a live person, 24/7. Call (888) 276-8078.
Written by the team at Groundwork Construction Co.












