







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Brentwood, CA: What to Expect
Concrete driveways and concrete work in Brentwood, CA typically run $4,500 – $12,000 for a full driveway pour, with most single-drive jobs landing in the $6,000 – $9,000 range depending on square footage, thickness, and finish. A standard pour takes three to five working days from demo to first drive: one day to tear out and grade, one to set forms and rebar, a morning to pour and finish, then a curing window before you park on it. Call (888) 276-8078 for a free on-site estimate with real numbers, not a ballpark.
How a Brentwood Concrete Driveway Gets Built, Stage by Stage

Concrete work rewards sequence. Skip a step here and you’re patching cracks in three summers. Here’s the order we follow on a Brentwood drive, with the decisions that land on you at each point.
Stage 1: Demo and haul-off (day one)
We break out the old slab, load it, and haul it. Most Brentwood drives are 400 – 700 square feet, so a clean tear-out runs 4 – 8 hours with a crew and a dumpster on site. You decide whether any sound sections stay or whether we take the whole slab. On a drive that’s heaved or cracked through, taking it all is almost always the smarter money.
Stage 2: Subgrade prep and grading (day one into day two)
This is where the job is won or lost. We strip to native soil, compact in lifts, and grade for positive drainage away from the house and toward the street or a swale. On the older lots near First and Second Streets downtown, that sometimes means chasing a low spot that’s been pooling for years. You’ll be asked about drainage direction and whether you want a channel drain at the garage apron.
Stage 3: Forms, rebar, and inspection (day two)
We set forms to your width and any curves, lay #3 or #4 rebar on a grid, and tie it on chairs so it sits in the middle of the slab, not on the dirt. Standard residential thickness is 4 inches; we go to 5 or 6 inches where a heavy truck or RV parks. If a permit is required, the inspection happens before the pour, and you don’t get a second chance once the mud’s in.
Stage 4: The pour and finish (day three, morning)
Concrete arrives by truck, gets placed, screeded, floated, and finished. This is your big decision point: broom finish for grip, a light salt finish for texture, or an exposed-aggregate border. We cut control joints within 12 – 24 hours so the slab cracks where we want it to, not where it feels like it.
Stage 5: Cure and striping (days three through seven)
We pull forms, backfill edges, and keep light traffic off for at least 24 – 48 hours and vehicles off for roughly seven days. Full cure takes about 28 days, though it’s drive-ready well before that. If you want expansion-joint sealant or a decorative border, that’s a same-week add.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Concrete Options You’ll Actually Choose Between
Concrete isn’t one product. These are the forks in the road on a Brentwood drive or flatwork job, with the honest trade-off on each:
- Standard broom-finish concrete – the workhorse. Grippy, hides tire marks, and it’s the base price in every range on this page. Boring, and it will show hairline cracks over time like any slab.
- Exposed aggregate – pea gravel washed to the surface for texture and a warmer look. Adds roughly $2 – $4 per square foot and holds up well in Brentwood’s sun, but it’s rougher underfoot and harder to shovel.
- Stamped or colored concrete – the decorative route. Looks like pavers or stone at a fraction of paver cost, but stamping adds labor and the color can fade in intense East Contra Costa sun. Worth it on visible aprons and walkways, less so on a working drive.
- 4-inch vs. 6-inch thickness – 4 inches suits cars and light trucks. If an RV, boat, or heavy work truck parks on it, go thicker with more rebar. The upgrade is cheap insurance against a cracked slab.
- Control joints and expansion joints – not glamorous, but they’re the difference between a clean drive and a spiderweb. We cut them on every job.
- Rebar vs. mesh – rebar on chairs is the premium call and what we recommend for driveways. Wire mesh is cheaper and fine for lighter flatwork like a walkway.
Surface color and finish aside, the material brands we lean on across the trades (Cambria and Silestone for interior stonework, for instance) don’t apply to a slab, but the same standard does: use the right product for the load it has to carry.
What Concrete Driveways & Concrete Work Costs in Brentwood, CA

Concrete driveway installation in Brentwood runs $4,500 – $12,000, and driveway replacement (demo plus new pour) lands at $5,000 – $14,000. A standalone slab, walkway, or apron pour typically falls within the lower half of that driveway range. Here’s what pushes a job from the low end to the high end:
- Square footage and thickness – a 400-square-foot drive at 4 inches is the low anchor. A 700-square-foot drive at 6 inches with rebar sits near the top.
- Demo and haul-off – breaking out and disposing of an old slab adds real cost. A clean lot with no tear-out keeps you low.
- Site conditions – soft or expansive soil, poor existing drainage, or a slope needing retaining work all push the number up. This matters more in Brentwood than most people expect (more on that below).
- Finish and decorative work – broom is base; stamped, colored, or exposed aggregate add per-square-foot cost.
- Permit scope – a straightforward residential pour is usually permit-light, but grading or drainage changes can trigger one. We pull permits and pass inspections on the jobs that need them.
Every written estimate is line-item: square footage, thickness, rebar, finish, demo, haul-off, and permit fees broken out so you can see exactly where the money goes. Upfront pricing, no surprises – the number you see is the number you pay. If you’re folding the concrete into a wider front-yard project, our Driveway & Pavers in Brentwood page covers the bigger scope.
See the difference
Before
After
Before
After
Before
AfterWhat Brentwood Homes Specifically Do to This Job
Brentwood is a town that spent two decades turning orchards and pasture into large master-planned subdivisions, and that history shows up under the slab. On newly graded former farmland in Brentwood, crews regularly hit old irrigation lines, land-leveling grades, and unrecorded ag-era wells or drain tiles that were never on the subdivision maps. That’s an underground surprise Antioch infill lots rarely produce, and it can add half a day of excavation and a change to the drainage plan. The dominant housing stock here is late-1990s-to-2020s stucco-and-tile homes in planned communities, so most of our concrete work is new pours and upgrades rather than historic renovation, plus a smaller older core near First and Second Streets downtown where drainage and settling are the recurring issues. Brentwood’s hot, dry summers and winter wet season also mean we schedule pours around heat (concrete sets fast and can crack if it dries too quickly) and around rain windows. If the driveway is part of a larger addition or new build, homeowners often pair this with ADU Site Prep & Utilities in Brentwood or Door Installation in Brentwood while the site is already torn up.
Serving Brentwood, CA – Our Local Coverage Area
We serve Brentwood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Concrete Driveways & Concrete Work in Brentwood

A standard concrete driveway in Brentwood takes three to five working days from demo to a drive-ready surface, with full cure around 28 days. Weather is the main wildcard: a winter rain window can push the pour a few days. Call (888) 276-8078 to get a timeline for your specific site.
Most straightforward residential concrete driveways in Brentwood don’t require a building permit, but any grading, drainage change, or work near the right-of-way can trigger one. We confirm what your job needs and pull permits and pass inspections where required. Call (888) 276-8078 and we’ll tell you upfront what applies to your address.
A concrete overlay is possible over a sound, stable slab, but it’s not the right call on a cracked, heaved, or settling drive. In Brentwood we usually recommend full replacement when the base has failed, because an overlay just hides the problem. Call (888) 276-8078 for an honest assessment of whether yours can be saved.
Concrete driveway work in Brentwood runs $4,500 – $12,000, with replacement at $5,000 – $14,000. With upfront pricing, the number in your written, line-item estimate is the number you pay – no change orders unless you request a scope change. Call (888) 276-8078 for an exact quote – estimates are free.
Every concrete driveway and flatwork job we do is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction. Call (888) 276-8078 to walk through what the promise covers on your project.
Get a Free Concrete Estimate in Brentwood
If you’re pricing a concrete driveway or flatwork job in Brentwood, start with a free on-site estimate. We’ll measure your existing surface, check drainage and soil, and hand you a written line-item quote with a real timeline and a fixed price. Call (888) 276-8078 – a live person answers around the clock – and we’ll set a time to walk your driveway. Our Brentwood service page and our broader Driveway & Pavers work give you the full picture.
Written by the team at Groundwork Construction Co.












