







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Brentwood, CA: What to Expect
Paver driveways in Brentwood usually run $7,000 – $18,000 installed, and a typical two- to three-car drive takes 4 to 7 working days from demolition to the last sand sweep. That figure covers excavation, a compacted aggregate base, edge restraints, the pavers themselves, and polymeric joint sand. Call (888) 276-8078 and we’ll walk your property, measure the actual square footage, and give you a written line-item number before any work is scheduled.
How We Build a Paver Driveway, Start to Finish

Paver work lives or dies in the base. We spend more days on what’s underneath the driveway than on the surface you see, and that’s the part most bids skip.
Day 1: Layout, demo, and what gets hauled away
We mark the new driveway footprint with paint and string, confirm grade and drainage direction with you on site, and saw-cut and break out the existing surface. On most Brentwood drives that’s old concrete or asphalt over a compacted subgrade. Debris goes into a dumpster the same day. You decide the layout and grade here: where water should sheet off, whether you want a slight crown, and where the driveway meets the garage apron.
Days 2 – 3: Excavation and base prep at depth
We excavate to 8 – 12 inches below finished grade depending on your soil and traffic load, then bring in crushed aggregate base and compact it in lifts with a plate compactor until it rings solid. This is the stage where a Brentwood lot surprises you. Former orchard land can turn up old irrigation lines, land-leveling stakes, or a buried drain tile that isn’t on any subdivision map, and we stop, show you, and talk through the fix before backfilling. You decide whether to cap an abandoned line or reroute it now.
Days 3 – 4: Edge restraint and paver setting
We set edge restraints along the drive’s perimeter so the field can’t spread, then lay the bedding sand and set the pavers in your chosen pattern. Expect to commit to pattern and border detail by this point: running bond, herringbone, a soldier course border, or a contrasting color band. Curved aprons and tighter patterns add labor and eat more cut pavers, which is where budget tension shows up.
Day 4 – 5: Cutting, compaction, and joint sand
We cut the perimeter and any curves with a wet saw, run a plate compactor over the field to seat the pavers into the bedding sand, then fill the joints with polymeric sand and water it to set. You’ll want to stay off the surface for at least 24 hours and keep vehicles off the sealed joints for several days. This is also when we check that water still flows away from the garage, not toward it.
Final walkthrough
We walk the finished driveway with you, point out the expansion and control details, and hand over care instructions: keep the surface swept, avoid de-icing salt, and plan to re-sand joints every few years. Any defect in our workmanship is covered under the 730-Day Done Right Promise – if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices You’ll Actually Make
The material and pattern decisions shape both the look and the final number. Here’s the honest trade-off on each:
- Concrete pavers (interlocking) – $7,000 – $18,000 for a typical Brentwood drive. Cast or extruded concrete with a color-through pigment. Holds color, resists fading under inland sun, and a damaged paver can be popped and replaced without tearing up the drive. The workhorse choice for most homes here.
- Clay brick pavers – at the top of the range or above it. Classic look, heavy colorfastness, no fading; costs more and can chip under heavy loads. Suits the older downtown core near First and Second Streets.
- Pattern and border – running bond is the most economical. Herringbone adds labor and cuts. A soldier-course border or color band raises cost modestly but frames the apron cleanly.
- Sealer vs. no sealer – sealing darkens the color and helps block staining but isn’t required; it’s optional upkeep, not a structural need.
- Edge restraint and base thickness – a thicker base and heavier restraint cost more up front but are what keep the drive flat over the next 20 years. This is where cutting corners shows up first.
The brand names you may see alongside pavers on a project like this come from our fence and hardscape partners – Barrette, Master Halco, and Ameristar are ones we work with – but the paver line itself is chosen by color, finish, and grade, and we walk you through samples in person.
What Paver Driveways Cost in Brentwood, CA

Plan on $7,000 – $18,000 for the install, with most Brentwood jobs landing in the middle of that band. What pushes a job to the low or high end:
- Square footage – a single-car-width drive sits near the bottom; a three-car apron with a turnaround pushes toward the top.
- Existing condition and demo – tearing out old concrete or asphalt and hauling it away adds cost; a clean subgrade saves it.
- Base depth and soil – sandy or former-orchard soil that needs more excavation and imported base costs more.
- Material grade and pattern – standard concrete pavers in running bond are the value pick; brick, tighter patterns, and custom borders raise labor and cut waste.
- Drainage and grade work – if the drive needs regrading, a swale, or a drainage line to keep water off the garage, that’s a real line item.
A written estimate from us lists each of those separately: demo, haul-off, excavation, base material, edge restraint, pavers, sand, and the finishing. Items that usually aren’t in a base paver number: relocating a gas or water line, a new drainage system, or a permit fee. We tell you upfront whether any of those are likely on your property. Our pricing is upfront with no surprises – the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhy Brentwood Lots Change This Job
Brentwood has grown fast at the suburban-agricultural edge. Over the last two decades orchards and pasture became large master-planned subdivisions, and new phases are still opening next to land in active vineyards and orchards. That means a lot of paver drive jobs here run into the underground remnants of the farmland that came before: old irrigation lines, grade stakes from land-leveling, and unrecorded ag-era wells or drain tiles that never made it onto the subdivision map. Antioch and Oakley infill lots rarely produce those surprises, but they’re common on the western and eastern edges of Brentwood in ZIP 94513.
The dominant housing stock here is late-1990s to 2020s stucco-and-tile suburban homes, though the older core along First and Second Streets has a different set of driveway problems. Either way, the inland heat matters. Summers bring intense sun exposure and fast-drying concrete pours, and the winter wet season is when we schedule grading and compaction. Expansion soils on former farmland need proper base prep and drainage or the pavers will rock within a year. Some subdivisions also carry HOA rules on driveway color and finish, so check before you buy samples. We’ll handle the on-site layout and grade work; if your driveway is part of a full Driveway & Pavers in Brentwood project, we’ll scope both together.
For the broader scope of hardscape work, see our Driveway & Pavers service, and to see how we cover the whole city, visit Brentwood. Homeowners who are reworking the front of the house often pair a new drive with Door Installation in Brentwood, and some pair it with Cabinets & Countertops in Brentwood during a larger interior update.
Serving Brentwood, CA – Our Local Coverage Area
We serve Brentwood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Paver Driveways in Brentwood

Most paver driveways take 4 to 7 working days from demo to final joint sand – the base prep is the longest stage, and the installation itself is faster. Small single-width drives can finish in 3 to 4 days; larger drives with pattern changes and drainage work run toward the top end. Call (888) 276-8078 for an exact timeline on your property.
Whether you need a permit depends on the scope: a straight swap of pavement usually doesn’t require one, but regrading, drainage changes, or work that touches the right-of-way can. We’ll tell you on the estimate visit what applies to your lot. Call (888) 276-8078 and we’ll sort out the details before any work starts.
Overlaying pavers directly on sound, intact concrete is possible but risky – the concrete has to be level and stable, and any cracking will telegraph through. In most cases we recommend full removal and a proper base, because a paver driveway on a bad substrate will rock and fail. We’ll assess your concrete and give you an honest recommendation.
Expect $7,000 – $18,000 installed, with most Brentwood jobs in the middle. A single-width drive comes in lower; a three-car apron with a turnaround, custom border, and drainage work runs higher. Call (888) 276-8078 for a free, line-item estimate tailored to your square footage.
Our workmanship is backed by the 730-Day Done Right Promise – if it’s not done right, we make it right, for two full years. The pavers themselves carry the manufacturer’s warranty, and we walk you through what it covers at the final walkthrough. Call (888) 276-8078 to schedule your free estimate.
Get a Free Paver Driveway Estimate in Brentwood
We’ll come out, measure your drive, look at the soil and drainage, and give you a written line-item estimate with a clear price and no surprises. Our technicians have up to 12 years of experience, and we’re licensed and insured. Calls are answered by a live person, 24/7, and we offer 0% financing for 18 months plus $1,000 off projects over $10,000. Call (888) 276-8078 to schedule your free estimate.
Written by the team at Groundwork Construction Co.












